Next, use an extra-fine sanding band along with the drill oil.Remove the dead excess skin by circling over it with the bit. Holding it horizontally, move it from one lateral fold to the other. Use a speed ranging from 2,500-6,000 RPM.Comfort says the oil helps make contact across the skin so the bit goes nice and smooth around the nail. Then, using the bit along with a drill-friendly oil, remove any ridges and smooth the nail’s texture. ![]() Gently push back the cuticle, exposing any dead excess skin.Type of bit to use: Extra-fine diamond, extra-fine sanding band, or silicone “As long as it’s done properly and with the right tools, an electric file on the natural nail can be just as safe as a regular nail file,” says Comfort. Do not attempt to maneuver the electric file around the client’s nails. Adjust the client’s hand to fit your needs.Come up on the cuticle to remove any dead excess skin. Always lift the bit off the nail after a few strokes so that heat doesn’t build up. Using minimal pressure, go over the entire surface from left to right and back again, making sure you have not left any part of the nail untouched. Using a speed of 2,000 RPM, hold the bit flat against the nail.Push back the cuticles so the bit doesn’t grab onto the skin.Type of bit to use: Either a fine sanding band, medium to fine diamond, or a coarse silicone Doing a proper prep ensures the nails will adhere longer and prevents the possibility of any product lifting. Getting the nails ready for a full set is one of the most important steps in artificial nail application. Only remove enough material to make your repair and move on. Apply even pressure starting from the outer perimeter of the nail, going in toward the crack. If you go too slowly, it can cause the machine to vibrate and send air pockets into the nail. Drill out the crack using a low speed ranging from 3,500-6,000 RPM, depending on the machine.The nail is still shiny and smooth and you can still see the definition of the crack. Begin work on the crack before prepping the nail. ![]() Type of bit to use: Mini French-filled diamond Continue with the fill as usual.Ĭracks appear too often on acrylic nails, but with the help of an electric file they can easily be removed, says Comfort.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |